eric m
New member
I installed a throttle controller in my JK. Huge improvement in throttle response, especially with the 6sp.
Sent from my iPhone using Jeepz.com mobile app
What did you do to your Jeep today?
- Thread starter wwch99tj
- Start date
I installed a throttle controller in my JK. Huge improvement in throttle response, especially with the 6sp.
Sent from my iPhone using Jeepz.com mobile app
Turbogus
Active member
After several months got the off road and for lights working again. Bad ground on the off road lights and on the latter when I installed the single DIN Pioneer head unit into the dash I knocked the connector off of the switch... Of course I traced the entire wiring harness for the lights before looking at the switch. Sometimes I can just feel those donkey ears spring up.
JPNinPA
Well-known member
PaulBunyan
New member
I installed a PCV valve and drank a beer while... Top that
Sent from my SM-G930V using Jeepz.com mobile app
Sent from my SM-G930V using Jeepz.com mobile app
Installed a new battery and replaced the front pads. Then I decided to order this tire-- super swamper SSR. I know these tires are not so street-friendly but my YJ is not a DD.
I have a feeling I'm going to have to do that soon. I haven't started my Jeep in a month.
That carpet looks much better than my 05's. I'm jealous.
I just installed a set of wheel and tires that I recently ordered for my 2013 Jeep Wrangler Unlimited Sahara. It's a combo of Nitto Terra Grappler tires and Fuel Off-road Ammo rims.
What is the size you installed? I'm driving a 2015 Jeep Wrangler JK, wondering when to choose new all-season tires for it, old tires being falken tires
Oldchief
New member
Finished up install of new Smittybilt XRC seats, to replace worn front seats of my '08 JK. Not a direct swap project and had to do some on-site 'engineering' to get them in and working as they should...most of which involved getting the back and forth seat adjusters to work properly. Done now and lookin good. While seats were out, also, added a Bestop under seat lock box under driver's seat where my Glock rides.
Last edited:
Finished up install of new Smittybilt XRC seats, to replace worn front seats of my '08 JK. Not a direct swap project and had to do some on-site 'engineering' to get them in and working as they should...most of which involved getting the back and forth seat adjusters to work properly. Done now and lookin good. While seats were out, also, added a Bestop under seat lock box under driver's seat where my Glock rides.
We need pics!
Delta62
New member
It's hard to tell from the photo - how bad is the scratch?
Similar threads
