Removing factory bumperettes??

Jason4x4

New member
How does one remove the factory bumperettes (the rubber protusions from the front of the bumper just inside the factory tow hooks facing foward on the vertical surface of the bumper) on an '06 TJ??
 

An oak tree will usually do it. If that doesn't work, try some hand tools.






Sorry, couldn't resist.
 
I haven't studied the TJ bumpers enough to give you detailed info on removing the bumperettes. It would be my guess that if you can't access the bumperette bolts, then you may have to remove the bumper to get to them.
 

torch and flat-head, then an appropriate hand tool


get the flat head red hot and slice them off. Then undo the fasteners to get off the rest.
 
hoobness said:
torch and flat-head, then an appropriate hand tool


get the flat head red hot and slice them off. Then undo the fasteners to get off the rest.

Well, I was hoping to be able to reinstall them - are you saying that there's no hardware holding them on?? I just have to cut/rip them off?
 
Best I remember (and it's been quite a while), I believe there's just a couple of nuts holding them on (there's a little stud running through them). And I believe there's access through that cheap arse factory bumper.......but you might have to take the bumper off - no big deal, really. I think I first removed mine when I mounted my high-lift jack up there (which involved removing the bumper). Bumperettes and factory bumper are all gone now, so that's all from three years ago in a 50+ year old burnt-out memory.:lol: :lol: :lol: :lol:

Hope that helped somewhat.
 

My 04 had maybe 3 torx screws holding them on but the 06s may be different. Take a look right on top of the metal part of the bumper next to the plastic end. Or bottom, I can't remember. There should be a pretty obvious way to remove them. Knowing Jeep, it's probably a torx head.
 
There torx head and have clips instead of nuts there kinda of tricky to get off.My wife couldn't get them all off so she just used the angle grinder and cut them off.
 

joedirt said:
There torx head and have clips instead of nuts there kinda of tricky to get off.My wife couldn't get them all off so she just used the angle grinder and cut them off.
Mabye I can get my wife to do a bigger lift and a motor swap on mine........ya right!......she hates the jeep.
 
Forget my earlier response. I didn't read close enough. I thought he was trying to get the plastic bumper ENDS off but rereading his post he is clearly trying to get off the forward facing rubber thingies on the front of the bumper. My bad.
 
Craig said:
Mabye I can get my wife to do a bigger lift and a motor swap on mine........ya right!......she hates the jeep.

yours too? :D
actually, she just hates the exhaust or lack thereof (headers anyone?)
 
Back
Top