RE: Re: RE: Re: RE: Re: RE: I shimmie
i installed the motorcraft 2100 conversion in my cj7. I test fired it and it fired up without a problem. Once I continued the install, putting on the accelerator and what not, the engine wouldnt fire. I thought I shorted something out because there was a weak/no spark at the coil. So I went thought the harness between the coil and the ignition module but havent found anything melted or out of place. Im not sure if i got a bad ignition module but I was wondering if anyone knew of anything or if anyone has had this problem. Im just hoping you guys can help before I go with a painless wiring harness, new ignition module, and distributor. By the way I replaced the coil, coil wire, and distributor cap recently.
i installed the motorcraft 2100 conversion in my cj7. I test fired it and it fired up without a problem. Once I continued the install, putting on the accelerator and what not, the engine wouldnt fire. I thought I shorted something out because there was a weak/no spark at the coil. So I went thought the harness between the coil and the ignition module but havent found anything melted or out of place. Im not sure if i got a bad ignition module but I was wondering if anyone knew of anything or if anyone has had this problem. Im just hoping you guys can help before I go with a painless wiring harness, new ignition module, and distributor. By the way I replaced the coil, coil wire, and distributor cap recently.