DIY? How hard is it to remove/install factory bumper on TJ?

[Chloe_A]

Hi
I want to remove my old factory bumper and put on a new factory bumper (other one was hit) I have the part...does anyone know if this is an easy task? Has anyone done it before and have any tips?
I have a '97. Thanksurple:

 

[90growler]

I would invest in either a Haynes or Chilton's Manual. Both explain how to do almost anything. A must for any Jeeper. You find them at any parts store.

http://www.partsamerica.com/Books.aspx

 

[Chloe_A]

thanks for the reply. I am just needing to get this bumper on then I am selling it...I just put tons of money into the mechanics, I don't really want to spend any more $$ on this car... it looks like a few bolts, and was wondering if I could just throw it on myself.

 

[Sparky-Watts]

Yeah, it's really pretty simple, I doubt you'll have any problems. I wouldn't wasted money on a Haynes manual, and probably wouldn't on a Chilton, either. They won't show you how to do any body work, just mechanical and electrical, and even then the instructions aren't the best.

 

[southtj]

It should just unbolt and the new one should bolt back on using the factory holes.

 

[dingus]

start spraying those bolts with PB Blaster or WD40 a day or so before you try takin those bolts out!

 

[Chloe_A]

thanks everybody...heehee, yeah I've been spraying WD40 like it's nobodys business...
I tried unscrewing them, and damn, they're tight...I will keep spraying, otherwise the autobody says it won't take more than an hour @ $36... not too bad.
Thanks again