Search results

yesterday I was pulling into a parking spot when all of a sudden smoke started to pour out from under my car on either side and into my tub. I got an 83cj7 by the way. I opened up the hood and looked for where the smoke was coming from. It was pouring out of connection between the exhaust and...

i installed a 3/4" shackle lift with my 4" lift kit on my cj7. The shackle have a center pin but when I installed the shackles, the outside bolts tighted down but the center pin seems to be too wide. Now the shackles are bending in. My question is can I just remove that middle bolt so theres...

RE: 1994 Cherokee Country For Sale its at the caliper

Leaky Differentials I replaced my calipers on my front brakes and then started to bleed all the brakes. When I got to the front, the extended brake hoses I installed started to leak. The connection is tight w/ the caliper so I dont know why this is happening. Any help would be great

i need help with this bad i dont want to have to take it to a garage and piss away money please help!!!

RE: Best lift to get? derff- im putting a manuel choke on the carb so i left the electric choke hanging off. If that did short out how would I go about fixing it all?????????

RE: Re: RE: Re: RE: Re: RE: I shimmie i installed the motorcraft 2100 conversion in my cj7. I test fired it and it fired up without a problem. Once I continued the install, putting on the accelerator and what not, the engine wouldnt fire. I thought I shorted something out because there was a...

RE: Extra Gas tank does anyone know the part number for the carb? I have come across the 2100 and 2150 on different carb sites but there are all different ones for different model cars.

Cigarette lighter socket and tach install: fuses? i have decided to go with the motorcraft conversion for my 83cj7. I was wondering if anyone knew of where I could find the whole conversion. I found it on ebay but I was wondering if there was a store or online store I could get it from. Any...

Skid Plate - Cat Help the hoses seem fine. Im just going to go ahead and replace the carb. Any ideas on a great upgrade from my shitty carb I have now. Keep in mind im a college student with a very limited income.

RE: Re: 1999 Jeep Grand Cherokee Limited For Sale im not sure what carb is on it probably the carter. it says remanufactured on it

my 83 cj7 has been hesitating for the past week. I replaced the distributor cover and wires and the fuel filter but I don't know what is causing it to hesitate as I accelerate. Any ideas??

Re: Vacation pics i got a 83cj7 with a your usual 2bbl carb. Last week it would crank but wouldnt fire. I had to replace the distributor cover, wires, and rotor. Now it starts but its bogging when I drive. My friend was checking out my carb when I had the problem before and he took it off...

RE: Ginger or Mary Ann? im putting in speakers into the grilles on the dash on my cj7. I was wondering if anyone knew the size nut I needed to use on the 4 post studs around the grille for each speakers???

i have an 83 cj7, i went outside this morning to start it up to take it into the shop for a tune up and it wont start. It turns over fine and I got plenty of juice, but it wont catch. I always have to give it gas but it wouldnt help today. I could smell the gas but im guessing its just from...

hey im from the boston area and my dad is getting an 05Lj and he is planning on getting a lift and i wanted to know if anyone knew of a shop that would install it close to boston. I live just north of boston if that helps, thanks

i got an 83 cj7 with a rebuild 258 with only 4000 miles on it. I went out to start it up today in the cold and it started but the second I took my foot off the clutch it stalled out. I started it back up and started to rev the engine alittle to try and keep it from stalling. But everytime i...

im replacing my seats with bestop seats. My drivers side slider is held in by a hex looking bolt but i wanted to know if anyone knew what tool i need to loosen the bolts up. And also i wanted to know if anyone knew the bolt size for the rear seat.

I goofed... looking to swap out my dead 258 with a 360. Looking for one that will bolt right in and wont need much of a rebuilt or not one at all. Boston area so if anyone not too far away from boston has anything let me know

so the 360 should be a direct bolt on? I found one from this guy for $300 and he has a radiator. Im going to get that then get new motor mounts and also a painless wiring harness to rewire my jeep. My wiring is a mess as it is and I think it will make the swap alot easier. Any ideas on how...