Project "organ donor" complete lol

Ok everybody so im finally back. My 4x2 to 4x4 swap is complete and works perfect. Unfortunately I lost the phone that had all the build pics on it so all I can show you is the end result.
As far as projects like this go it was very easy(as easy as it COULD be anyway). All of my pedal mounts were the same, flexplate bolt pattern was the same, bellhousing bolt pattern was the same, the hardest part was cutting a hole in the firewall for the slave cylinder(clutch master cylinder).
Basically I swapped my 2wd automatic AW4 transmission for the Peugeot BA 10/5 5speed transmission with the NP231 t-case. I swapped my front and rear axles for the 4x4 front axle and rear axle all out of my 87 XJ Pioneer donor Jeep.
Here's a rundown of the total cost of everything,
Donor XJ: $450
Front brake rotors for new 4x4 axle: $80
New brake pads: $30
New pressure plate, throwout bearing, clutch disk and pilot bearing from perfection clutch systems: $186
Various fluids: about $50
2 more used 31x10.50's to make all sizes match: $40
Total cost of build: Around $800
Not bad for an 88' 4x4 XJ with a 2" lift and 31's lol here's some pics:shades:
 

Attachments

  • 224033_161470237245653_100001480337400_372262_4828354_n.jpg
    224033_161470237245653_100001480337400_372262_4828354_n.jpg
    98.7 KB · Views: 443
  • 195027_156857431040267_100001480337400_341697_7032964_o.jpg
    195027_156857431040267_100001480337400_341697_7032964_o.jpg
    179.9 KB · Views: 228
  • 216139_161470213912322_100001480337400_372260_5979154_n.jpg
    216139_161470213912322_100001480337400_372260_5979154_n.jpg
    123.6 KB · Views: 316
  • 217334_161470177245659_100001480337400_372259_6416480_n.jpg
    217334_161470177245659_100001480337400_372259_6416480_n.jpg
    124.6 KB · Views: 344
  • 224211_161470277245649_100001480337400_372264_2300669_n.jpg
    224211_161470277245649_100001480337400_372264_2300669_n.jpg
    109.2 KB · Views: 426

The new 5speed and 4x4 shifter.
 

Attachments

  • 215629_161470257245651_100001480337400_372263_2681630_n.jpg
    215629_161470257245651_100001480337400_372263_2681630_n.jpg
    76.8 KB · Views: 439
Good luck with the BA-10 they aren't known to be all that tough. That being said my step father has a 87 YJ with one and it has over 250k and is on it's second clutch.
 
Ya that's what I've heard, so im gonna take it easy on it for the most part, regular maintenance, etc. But if it ever does go then i'll definitely be finding and AX-15 to replace it lol
 
Back
Top