diamond plate rocker panels?

[rtoney9]

1070658

I'm thinking about putting some diamond plate rocker panels on my 95 YJ. I was wondering if any body knows if it is cheaper to get some cut from a sheet of it by a shop or just go ahead and buy them from a dealer? I'm on a tight budget, so I'm trying to find the best for the less.[addsig]

 

[Tug-n-pull]

1070743

The best for less is 3/16" to 1/4" by 4" x 4" angle iron. It does the job that he shinny stuff only loos like it will do. Rocker sliders out of angle will hold up the weight of the jeep and look good doing it. tug[addsig]

 

[TommyJeep]

1070769

Keep in mind that diamond plate doesn't slide well on rocks. If rocks aren't in your future, no problem. But if you like the rocks, I'd get smooth plate instead.

[addsig]

 

[USMPK9]

1070773

Nice, Very Nice, Tommy,

Bombproof and a Hi lift Jack
point too,,, Right...

What does something like
that run? [addsig]

 

[Tug-n-pull]

1070781

So did you just have that custom bent to fit under the body mount? Looks very nice. Tug[addsig]

 

[64Jeeper]

1070782

This guy makes all kinds of fabrication goodies.

Clicky Clicky[addsig]