1051711
Oh thats nothing...in the past 48 hours....I have:
Bolted a bellhousing, clutch components, and shift tower on my transmission
Bolted my NP231 onto said transmission
jacked, lifted, and grunted said transmission & NP231 into my jeep
bolted said transmssion to the engine
installed shifters for both items
installed rear driveshaft
connected all electrical connectors to transmission and Tcase
installed skid plate
Finding out the transmission was broken and needed repair I then:
removed skid plate
removed all electrical connectors
removed rear driveshaft
removed NP231 and transmission shifters
unbolted NP231 and heaved it out from under my jeep
unbolted the back half of the AX5 transmission
made necessary repairs (removal) to the 5th gear of said transmission
cleaned and applied gasket to halves of transmission
bolted transmission halves back together
jacked up and bolted NP231 into place
installed rear drive shaft
installed shifters
intstalled all electrical connectors
installed skid plate
And I still need to:
install front driveshaft
weld exaust crossover back on
fix and seal the vacuum connector for 4wd
and then maybe I will be done...whew I am beat.
I think I am going to go to bed now.
[addsig]