Search results

took it to the dealer they said it was the immobilizer and that it needed to be replaced as for the key i'm not sure i got it with the jeep and its black thats all i can tell u. i know i"m taking off the key ring and keeping it at the house from now on so this does not happen again. thanks for...

there is no spot for a key on the passenger door or the hatch. i found out that my brother inlaw used the jeep the other day and tried to start it with a key that didn't have a chip in it. it ran for 3 seconds then shut off. he then used the other key it ran great for a day and a half now...

i have an 04 grand cherokee with a 4.0 liter and at heres the problem. got up this morning and it wouldn't start. cranks but not start after looking around for a little noticed that the security light was on and not going off. when u turn the key on it comes on then goes off but comes back on...

i want to install an after market cd play in my jgc and wondered if i could hook up the factory 10 changer to it

ok now that i got the jeep running the trans takes a while to shift from second to drive. i was told that when i pulled the pcm that it had to relearn the shift point of coarse this was after beating for a little.. is there any way to set the shift points throught the computer?

why yes it does

nope just changed the pcm from my other grand cherokee that was blown up and i guess it wanted the steering column to match

nope it was the pcm

i got it finally after all of that i igot it it was the vtss. all i had to do is change some stuff in the steering colum. thanks you been a lot of help

yeah none of that here just coil packs is it possible to have the cam sensor off just enough that it starts and then stalls?

no it will start up but then die the only way to keep it running is to spray starting fluid in the throttle body. i did the steps you sent me and same thing i put a noid light in the injector harness and it pulses for a second or two then nothing and the motor stalls. would low fuel pressure...

no the light on top of the dash is not on so what else would kill the injector pulse?

ok did that still doesn't run long i traced it to no injector pulse after it starts someone told me its a problem with the vtss i tried disarming it and nothing is there anything else that would make the pcm stop the injector pulse after it starts?

00 grand cherokee 4.0l ok lets start with the latest had it running but not right change the cam positon sensor but pulled the oil pump shaft out too put it back the way all data said and not start changed the pcm and it started but only for a few seconds. it said about sync the fuel system...

timing is on have spark now it runs but only for a few seconds i changed the pcm and the cam position sensor and still doesn't run

i have a 00 grand cherokee with a 4.0l in it i replaced the crank position sensor and it doesn't want to run. it will fire some times and when it does it missses really bad. other times it won't even start. took the plugs out number 3 and for cyclinder look like their not firing. changed...

had it ripped apart and doesn't look to be anything rubbing i replace the left front wheel bearing it was starting to grind but the noise is still there. is there anyway to check the abs pump

it only did it when braking at first then when you hit a bump and now if your going around a hard corner there's no abs light on and the brakes are new front and back and new rotors on the front

thank you i have a broken wire in my door the lock only work if the door is in the right spot thinking thats where the problem is does anyone know about the noise while braking

do i have a problem no ever heard of