Search results

I'm cherishing this moment every time I go to fill up. It's just takes a little over $20.00 . As far as the economy is concerned, not good. A lot of people lost their jobs from layoffs unless your in production. 9000 from BP corporation alone. The other companies also have done the same. This...

Welcome to Jeepz.com Check the dimmer knob. If it's turned all the way down, the dash lamps will be dim. It also over rides the interior lamps when you pass the detent while turning the knob or wheel. Sent from my iPad using Jeepz

Nope! But I do have a you tube video somewhere a while back of my quad"drone" and a video of my 4 1/2 foot Heli that I built. Sent from my iPad using Jeepz

Check your PM.. Part numbers are listed and options. Sent from my iPad using Jeepz

D MAC, PM me your VIN number. Sent from my iPad using Jeepz

Welcome to Jeepz.com Sent from my iPad using Jeepz

Mine too. Sent from my iPad using Jeepz

I'm not sure if there is any other tool available out there that can do the same as the DRB3 .. Yes, the cam and crank sync should be as close to 0 as possible. Sent from my iPad using Jeepz

I rarely fire up my laptop at home. So far it's all good with my iPad.👍 Sent from my iPad using Jeepz

I did last weekend. Axis buck and a white tail doe. 😜 Sent from my iPad using Jeepz

Taking some old mental notes from my past experience , I found the same issue with my 81 CJ7. What I've found is that the signal wire to the coil is a resistor. Full 12 at cold start and resistive after a few seconds. After warm up, the wire opens and causes the shut down. Prior to this...

Or you might be able to check on a local dealer and see if they can locate it on their parts diagram and check if that spring is still available. Sent from my iPad using Jeepz

That YJ hardtop should fit the CJ. Is there something different about that YJ top? Sent from my iPad using Jeepz

That column looks like an old GM steering column like what I have on my 81CJ7. The actual electrical switch is down below the steering column housing/tube. A rod links the switch up towards the ignition key tumbler mechanical gear that is attached to that paddle you are referring to. Process of...

That's it. Check to see if the length of that channel is sufficient for the soft top header. If it's too long, cut the excess length from the middle and then install the channel to the windshield. Make sure you properly align the channels that meet in the center before you screw it on. Sent...

My thoughts exactly. Laws can be created but only the law abiding citizens are likely to follow them. In my opinion, if the property owner for example has a " privacy fence " my common sense tells me that the property owner wants their privacy within the confines of that fence. We can't own air...

I have built 2 450 class "drones" . Technically a quad copter. There's quite a bit of hobbyist out there that loves to fly drones. I also built a 700 class 3d helicopter. It's now getting an upgraded fuselage (Airwolf ) .. To me it's a hobby, flying with or without the GoPro mounted is fun...

Hard to tell where to start troubleshooting. Try to wiggle the steering wheel while turning the ignition and see if the steering wheel lock has any effect on the issue. If not, the ignition tumbler could be the only other issue I can think of.. Sent from my iPad using Jeepz

Or get a full length channel. Sent from my iPad using Jeepz

600,000 + miles is the most I've seen so far on a Jeep Cherokee 2dr with a 4.0liter. Never had any catastrophic failure. Always had its maintainance done. Sent from my iPad using Jeepz