two more things i built

[Snitty]

Here's my rear driveshaft.. it is a cherokee front CV shaft... I sleeved over it with one size larger pipe, and welded her up nice... then painted it black... she's working nice, no vibes... total cost approximately $2.50

Then here is my tracbar relocation bracket... WOW did this make a difference in how it drove... i didn't even have to move anywhere and i could tell the difference in stability... I thought it was just so tipsy because of the SOA and no shocks... I put this on, and holy crud was it stable... total cost $0.94

you can see the remnants of my plow mount that i haven't fully removed yet

there we go... your dose of snitty fab for the day

 

[mingez]

Can we coin that term? When it's bad work it's "Booty" fab. But when it's GOOD work it's '"Snitty" fab :mrgreen: . Nice stuff man.

Is that track bar bracket thicker than it looks though? What'd you make that out of?

 

[Snitty]

3/16"

 

[Bounty__Hunter]

SOA and driveshaft lookin good. I'd gusset the track bar bracket, bring it down and towards the driver's side and bolt it to the cast web of the disconnect housing.

 

[Snitty]

Some days you feel lucky, and some days you don't

i considered that.. i'm gonna watch how this works... from the start i wanted to triangulate the bracket anyway

 

[currupt4130]

looks good snitty, your probably right about the track bar, but i like mine without, i scare a lot of people when it rolls just a little more than theyre used to

 

[TwistedCU]

Looks good Snitty. Looks like your parallel too. My first thought was that the 3/16 might be too thin, but all the stress is side to side anyhow, so it really might not make a difference at all.

Hey that stock stabilizer is getting a workout now!

 

[Snitty]

well i field tested the monster today... and that bracket held up mighty fine... if i need thicker... i have a dollar for some thicker steel

 

[mud4feet]

if i need thicker... i have a dollar for some thicker steel

Haha! Great work, snitty! So........if I give you like, 5 bucks, you could fab me a brush gaurd to protect my winch, right?

 

[Snitty]

5 bucks will getcha a brushguard and a Snitty-fab redesigned rollcage

 

[west747]

looks good snitty! i really like the re-tube job.

 

[mud4feet]

5 bucks will getcha a brushguard and a Snitty-fab redesigned rollcage

:mrgreen: