Turtle
New member
1040143
Here I go, once again... The problem now is that I stall out everytime I stop at a light or am slowing down to make a turn. This can be quite scary at times, Especially when a Semi is approaching! This weekend I am replacing the engine due to a busted main bearing. So I am not sure if I am stalling due to a bad motor that should not be running, but must so the owner can get from A to B or is this a carburator that needs rebuilding? Any input would be greatly appreciated. I believe after this I should be all good as far as my jeep is concerned! (88YJ st.6)Is there anything in particular I should be looking for?
Appreciation in advance!
~EB
[addsig]
Here I go, once again... The problem now is that I stall out everytime I stop at a light or am slowing down to make a turn. This can be quite scary at times, Especially when a Semi is approaching! This weekend I am replacing the engine due to a busted main bearing. So I am not sure if I am stalling due to a bad motor that should not be running, but must so the owner can get from A to B or is this a carburator that needs rebuilding? Any input would be greatly appreciated. I believe after this I should be all good as far as my jeep is concerned! (88YJ st.6)Is there anything in particular I should be looking for?
Appreciation in advance!
~EB
[addsig]