New Jeep Questions

[MRJMF]

1065248

i just bought a 2000 wrangler but im not sure what options i have like abs and the like is there a way i can run my vin and see what i have sorry about the dumb newb question[addsig]

 

[K-Phat]

1065249

Hey welcome to the wonderful world of Jeeps. Running the VIN might work, but I'm not to sure about that. If you have ABS you sould get a green ABS dash light to come on for a few seconds when you turn on the Jeep. Hope this helps a little bit and enjoy the new wrangler [addsig]

 

[MRJMF]

1065267

ok ill have to look at that another question..whats the best way of cleaning dirt out of the engine bay?? is a pressure washer with soap ok or do i have to do it by hand?[addsig]

 

[tarsij]

1065274

just get some engine degreaser, spray the engine bay down with it and hose it off, being careful to avoid important electrical parts(you may want to put bags over these). Not sure about the pressure washer because it will probably blast right through the bags


TARSI[addsig]

 

[west747]

1065275

run the engine for a few mins and than spray it down with engine degreaser.,,even if it is just mud your washing off, degreaser makes the job easy..and yes you can use a pressure washer just make sure not to blast out any plug wires or vacum hoses. [addsig]

 

[judge09]

1065285

On a 2000 TJ I wouldnt even bother with the engine degreaser. I would seriously doubt or at least hope you dont have massive amounts of caked on grease in 3 years. I use to go through my 2000TJ all the time with wet rag. or if you want to get serious use some armorall after that. The engine bay isnt that large.[addsig]

 

[MRJMF]

1065293

no the engine doesnt have a spot of grease on it but is caked up with mud, next question any way to prevent mud/engine bay with fabin. a metal box...ie. a part you can buy?[addsig]