Mxpx182lit
New member
I have a 99 TJ and in the process of my last wheeling expidition i managed to snap the driver front conrol arem mouunt of the axle and mangle it up real nice. So today while looking at it an idea hit me. Would it be possible to real carefully cut the control are mounts of the bottoms of the axles and re-weld them on the top? I figure i could gain another inch or so of clearence in those areas and locate the mounts up and out of harms way. Also if this is posible, would it provide any lift? Any ideas, suggestions, concerns would be greatley appreciated.
