check engine light code 11

[luis]

Today I was driving and my jeep started to stumble and seem to "skip a beat" no cel came on but decided to do the ignition trick and 3 things came which were 12 which is battery. 11 which I don't understand and 55 end of test. I have a 97 tj 2.5 with a ax-5 transmission. I checked all the connections and they are fine. It seems to do it only at around 45mph. But that could be my mind playing tricks on me. It starts up fine and idles fine any opinions? What can I do?

 

[LGR]

11- No crank reference signal detected during engine cranking.

55- Completion of diagnostic trouble code display on the malfunction indicator lamp (check engine lamp).

 

[luis]

So what does 11 necessarly mean then? It starts up just fine. The light has not came on. I'm guessing its a pending code?

 

[JPNinPA]

Cam Position sensor.
Check that it is plugged in.
Be sure the battery connections are clean and tight - unless you just disconnected it.
Be usre the PCM connections are not loose

 

[JPNinPA]

The PCM is not detecting a signal from the cam sensor durring start up.

 

[luis]

Cam Position sensor.
Check that it is plugged in.
Be sure the battery connections are clean and tight - unless you just disconnected it.
Be usre the PCM connections are not loose

Ya I disconnected the battery a few days ago. Where is the cam sensor? It's in the dizzy right?

 

[JPNinPA]

 

[luis]

I'll be sure to look at that thank you

 

[luis]

I looked early this morning and the wiring is connected and is in good condition