engine

Anyone looking for an 88 Wrangler? I'm looking to sell my Jeep. I live in northeast NJ. Engine only has about 15k on it.

Hi folks. I'd be a new Jeep owner if I was to do this, here's my question: Is it possible to install a 4.0 inline 6 (that is currently in a 1995 Cherokee Laredo - that engine itself was a fully rebuilt one installed 3 years ago) into a 2000 Cherokee Laredo that currently has a V8 in it - with...

Hi everyone, I recently bought a resotred CJ5, physicaly beautiful, but upon inspection of the engine bay, I knew few things were not properly done. I am not sure what diagram would fit my setup so I am looking for some help. Also what parts could fit for the CTO Switch and PCV Valve? This is...

So I spent months building a stroker for my '98 TJ. Got it in, hooked everything up- won't turn over. When I was pulling the motor I forgot to disconnect the battery (duh) and grounded something out that melted the fusible link. I replaced that and have tried the following: Checked every...

I have an 94 yj, 6 cyl standard transmission. Also a 94 Cherokee,6 cyl, automatic. The cherokee is rusted out bad and there is something wrong with the engine. Wondering what parts from the cherokee would fit the yj. Sreering gear box, transfer case, rearend etc. Thanks.

2012 Jeep Liberty. No matter what I turn the dials to, the fan blows constantly when I start the engine. And no matter if I put it on vents, the defrost air is blowing.

HMU if interested, Nevada area Valve cover tag 611N27 6= 1973 11= November N = 360 2V 27= 27th day of November Cylinder head ID 3216090-1 1973 57.92 cc intake 2.025 exhaust 1.68 dog-leg pivot Complete engine came out of a running Wag long ago. Turns over freely by hand. Also have a cast...

I have a 2011 JGC Overland V6, 160k miles. Replaced Cat Conv in Sept, then noticed engine running rough. Eventually CEL came on. Mech said cylinder misfire 2, but the oil cooler was bad and needed to be replaced. Done. One week later, CEL came back and now read Cylinder misfire for 2-4-6...

I recently found a very rusty 1989 Jeep Wrangler with an HO 4.0 Engine. I also own a 1998 Cherokee with a solid body but no oil pressure at idle on a 4.0, HO engine. I was wondering if there are any major differences between the two engines that would make them difficult to swap. I would like...

I'm selling an engine from my 92 YJ, it's a 2.4L 4 cyl. It has about 150K miles and it's working great. I used it with premium gas and frequent oil changes. Selling because I did a engine upgrade with a more powerful one.

First time poster here...Earlier this week I had a blown head gasket replaced on my 2001 Cherokee and my AC fixed after noticing oil in my coolant and my car overheating while driving on the interstate. When I got home from the mechanic after the repairs, I heard some hissing. I got out to...

I have a 1974 cj5 with the 304 v8. It has the Edelbrock Performer manifold with a Carter AFB- 4 barrel. I want to get rid of that carb because it gives me nothing but problems. My question is: has anyone ever tried using a Ford 4100 shoebox carb on this engine ? It is 625 cfm just like the afb...

Hello all, I am new on here and new to the world of jeeps. I just purchased a 1948 Willys Flat Fender CJ2A. It is overall in pretty good condition physically, and mechanically speaking it doesn't seem too bad either. One issue I am having is with turning it on (yes that seems like a pretty...

Anyone with a 2.5l 4 cyl knows that they aren't the most powerful beast under the hood so I am wonder what you have done to better its performance!

hey guys I have an amc 360 for trade. its been rebuild for no particular readon other than being old and not used for something like 10 years. it doesnt have a harmonic balancer(yet!), the water inlet is not in the pictures but I did install it (I think they are attached, let me know if they...

I've been driving it all day with no problem, but when I went to start it up before leaving my apartment this afternoon it started acting up. When I turn the key, it won't start - but the AC, radio, lights on the dash, etc. all still work. I guess that means it's not the battery (?) but I've had...

I purchased an engine to replace the one in my '91 Wrangler. The engine I bought came from a 1992 Cherokee. The clutch pilot bearings are different. Does anyone know how to adapt the pilot bearings in the '92 engine to fit into the 91's standard transmission? Is there a pilot bearing conversion...

My 1992 Jeep Cherokee was running fine, then one night I get in drive for like 10 seconds and it shut off. When trying to start immediately after the engine would turn but not start. Hours later it would start and run for a few seconds then die. After that happened for awhile now the engine wont...

So after the fire I am taking everyone's advice and parting out what I can of the CJ7. The roll bar is fine, the AMC 304 V8 , GM 400 Turbo trans, axles, Transfer Case, Hood, Fenders, Cragar Wheels, Tailgate, etc... I am in Chicago but willing to take offers on all parts. Please consider...

I have a in-line 6 jeep yj 1989. i have got a price of 2200 to do a full engine rebuild and i'm trying to find out if that's a good price or not. that is everything parts and man hours. i cant do it cuz i do not know anything about that kind of thing. so just give me your thoughts about the...