case

Today, at the off-road park, I lost 4 lo. My transfer case would shift into 2 hi, 4 hi & neutral but no 4 lo, just a spongey feeling in my shifter where 4 lo should be... well, I went to the articulation area to get a good look under the Jeep at the linkage and this is what I found. I'd...

To replace the transfer case shift motor the transfer case must be put into neutral. When button pushed with brake pressed and trans in neutral red light will blink but doesn't stay on. 4 wheel drive low and abs lights are on. Does anyone know of a work around to get the gear for the shift motor...

working with a 2016 Jeep Grand Cherokee I will start with I have very limited mechanical knowledge or experience, but I am afraid that there are issues beyond what I am being told, and not sure what my options are going forward. My car started with being locked in 4WHD low. took it to the...

I have an 88 YJ with a AMC 258 4.2 I6. It has the Aisin Warner AX15 5-Speed Manual Transmission. I am installing a Motorcarft 2150 carb. this weekend. I received the carb from a gentleman in Colorado that puts these kits together a few years ago. I have not messed with the Jeep for a while, but...

Just finished up swapping a '94 YJ 4.0 with an AX-15 into a '95 YJ and now on occasion when a let out the clutch I'm getting a LOUD popping coming out of the either the tranny or transfer case. I have the floor plate around the shifter removed so I'm hearing it real clear. All angles as far a...

Hello! New user here, came here to ask this question as I have no idea how to proceed with this issue. Recently took my 04 Grand Cherokee into the mechanic because it's been making a new funky noise. A grinding/scraping sound coming from under the engine... thought it may be a pulley (wishful...

8,900 Texas/Mississippi Rust Free 1990 JEEP YJ WRANGLER, ISLANDER V8, 1989 GMC Truck Chevy 350 V8 5.7L With ECM/OBD2 plug in. Mileage unknown, 700R4 Overdrive automatic transmission, 1800 rpm stall speed converter. Complete PAINLESS Wiring, This JEEP is not a hacked up off road only. Aftermarket...

Hi Everyone - My lift project is coming along. The front is done and I'm wrapping up the rear (I think!). But I have some cables that are too short and are keeping me from putting the axle back in place. I thought they were brake lines at first, but this is not the case. Perhaps they are ebrake...