Search results

Thanx for the info... much easier then the repair manual led me to believe

Thanx for info, have never replaced a ball joint on a jeep.... wasnt sure you could clear the axle to spin the knuckle

Replacing a lower (pax side) ball joint.... 2003 jeep liberty 3.7l. Manuals i have tell you to remove the wheel hub, one of the Hub bolts is completely rounded. Just curious before I get started on the rounded hub bolt and seperating the Knuckle from the upper and lower arms and tie rod end...

Thanx for all the input. Have checked for Vac leaks(none found). Transmission fluid good. Have read about the ECM short in other threads, Backed out the screws yesterday and not sure I believe it- but so far so good, jeep has not stalled, will get shorter screws today, and keep u posted. again...

98 GC 5.2 L -- when I come to a stop on an incline jeep shuts off and starts right back up ( no shuttering or rpm fluctuation,) can not duplicate the problem on level ground or downhill, only happens if stopped going up hill. No codes. Have done a complete tune up, cleaned throttle body and new...

Thanx for the info

Trying to change the "throttle position sensor" in a 2003 liberty 3.7 L, cannot get torx screws on old "tps' to budge, (have never changed one on a Jeep). dont want to do any damage. Anybody have any Ideas Thanx