Search results

And don't forget, there's a vacuum reservoir under the battery tray. Check the vacuum lines there too..

Your talking about the input and output speed sensors. If and when one of those sensors fails, you will have a correlation type DTC'S . This would typically be associated with that loss of speedo gauge.

The voltage difference is not enough to to make a big difference and since the resistance value stayed the same I would have to call that good however it wouldn't hurt to check the connections for loose pins or corrosion on the power and ground circuits. If you look at the other members issue ...

Testing it properly will require special equipment like a pressure gauge, fittings and special valve body pressure test block which is usually found in a dealership or a transmission shop. At this point, you said there is a noise coming from the torque converter area, this already justifies a...

Torque converter would be my first guess as well since there is an objectionable noise coming from it..

On a 96 GC, you can turn off the security system by using the door key tumbler. Place the key in the tumbler and turn it to the unlock position and this should turn off the security on this entry. If the driver side switch failed, use the passenger side.. A tell tale sign on the dash should...

First things first.. Check for fuel and ignition. I have reason to believe that this issue might be likely caused by an electrical issue. Check the main battery feed to the ignition switch, fuse block and the connections behind it. A wiggle test might help while the engine is running.

Chances are ,the connector has a loose pin or a pin doesn't have enough retention to keep a good contact.

Have you met the guys at Xtreme outfitters there yet? One of the Jeeps they have out there is a white JK truck that's kind setup like a retro style.. Tell Roy and Rodney, Mike Gonzales sent ya! They're cool folks!!

The most simple place to check and most common area for an air bag light issue is the connector under the front seats. Check the yellow connectors under the seat and the wiring. Do this with the negative battery cable disconnected and wait 5 mins before you check these connectors.

Yes it is! With custom patterns too. :)

3 Cerakote projects are done.

Also consider the time when the issue started. Re-check the starter wiring. Make sure nothing got pinched, or shorting out on the wiring around that area. Another place to check is in the ignition switch wiring. Do a wiggle test on the wiring , sometimes it help to isolate the source for bad...

Yes, the AMC 360 is a straight swap. If I remember correctly, I pulled mine out of a 79 Jeep Wagoneer. There's one thing you should look at before stabbing the engine in your jeep. I noticed on mine, there's a spacer on the rear of the crankshaft where the flywheel bolts into. You need to make...

If you decide to install the sensors back into the wheels, use the same ones if possible since the ID numbers on those sensors are already programmed into the module in the Jeep. IF you decide to put new ones in, makes sure you get the ones for a 2013 model. The previous 2012 sensors will NOT...

I miss my little Honda Civic I used to have.. Had over 400,000 miles on that 4banger and was still going strong until I got hit by a drunk driver. After 8 months, I was able to walk again and visited my o'l Honda on the yard. The engine was sitting almost at the top of the driver side fender and...

Have all your front end steering and suspension components checked by a qualified front end specialist if you don't know what to look for. Excess end play between a tie rod, ball joint and a steering gear box for example will give the total stacked amount of end play way out of the specified...

Go down six post from this one and click on the " door instructions" from member RSPI ..

That is the best way to do it, great job! .. There's an upside and a downside on either one of the 2 ways of servicing an automatic transmission. The conventional way doesn't clean out the fluid in the torque converter and the small ports and circuits in the valve body however , the filter is...

Great job!! Looking good!