Recent content by JPNinPA

They are really good. Never look down on anyone unless you are helping them up - Jesse Jackson

Thanks Terry! Replacing all injectors being they have gas puddled in the connector. Explains the gas smell under the hood. Thing was i couldn’t get the codes from the key dance. Never look down on anyone unless you are helping them up - Jesse Jackson

Awesome! Never look down on anyone unless you are helping them up - Jesse Jackson

Nope! The engine is misfiring. Engine light is blinking. Shut vehicle off then key on and the check engine light is on. Key dance -no codes in odometer Use code reader and see P0205 and P0305. Same when P0457 gas cap sets. No odometer display of code. ONDII reader sees the code. The...

2008 Jeep liberty 3.7 I’ve had the P0457 gas cap code a few times. After one or two times the key dance stopped working . It shows —————- then changes to dOne. Now having P0305 and P0205 code but the key dance shows nothing. So I had to drive to a shop for a code reader Has anyone run into...

I dont have all your answers but #2 is offset to not rub. If you recenter the tire in the wheel well it will rub before full turn. Also might catch inner wheel well when flexing. And those are some large lugs to rub. More like stop on. Never look down on anyone unless you are helping them up...

Anything?? New??? Never look down on anyone unless you are helping them up - Jesse Jackson

Yes. Replace inner and outer seals. Check axels for wear and scoring. Never look down on anyone unless you are helping them up - Jesse Jackson

Idk. Id first clean it off with brake cleaner. And see how long before it returns. Also be sure it is not a drip from above. Consider just replacing output shaft seal. Never look down on anyone unless you are helping them up - Jesse Jackson

Cool! I want one!!! Dang too costly to drive there. Never look down on anyone unless you are helping them up - Jesse Jackson

Good to know thanks! Never look down on anyone unless you are helping them up - Jesse Jackson

Here is a site with info. https://boltdepot.com/Fastener-Information/Materials-and-Grades/Bolt-Grade-Chart Id stay with the 11. If I were worried about sheer like let the bolt break before something else then run 8.8 Never look down on anyone unless you are helping them up - Jesse Jackson

Try here https://www.jeepz.com/forum/pages/vin/?vin=1JTMP6318HT118388 Never look down on anyone unless you are helping them up - Jesse Jackson

That would show on your plugs. And in an exhaust eval or coolant eval. Are you loosing any coolant? What is the number stamped on the head? One casting was prone to cracking between 3 & 4. Never look down on anyone unless you are helping them up - Jesse Jackson

The only other things i could think of and only if it tracks timing. Check odpa or distributor gear to CAM gear for wear. 2003-2006 ODPA did not self lube properly causing gear wear and eventually miss or screaming monkies. Second worn CAM lobes or bad lifter. Though these should cause a misfire...