Clutch just went to floor

[tablesaw]

It was fine yesterday, this morning clutch pedal goes to the floor. Fluid is full, I don't know anything about slave cylinders. '95 2.5 ax-5. Any advice?

 

[0III0forlife]

Sounds to me like the clutch master cylinder has a seal blown out in it. Mine did that. Wasn't leaking anywhere. had no clutch pedal, could pull it up by hand and it would stay, but it wont work the clutch. Found out it was an internal seal in the master cylinder. Not building any pressure. No resistance on the pedal.

 

[tablesaw]

Thank, I hope thats better than dealing with the slave cylinder. I'll dig into tomorrow.

 

[Gennybro]

That was my first thought, Master cylinder.

 

[tablesaw]

Thanks, that's exactly what it was. New MC and bleed clutch = good as new.

 

[tablesaw]

Update, clutch still slowly lost pedal so I went ahead and replaced the external slave cylinder. A lot about using a socket and punch to drive out old pin. If you only have two hands like me a 1/8 drill bit is a good friend. Pump bled the air a few times and then topped it off again the next evening and it's good.