ignition

Hey Guys, bought my first jeep 84CJ7 (project). Jeep starts up, backfires and will bog out if you try to drive it. Has new plugs/wires/distributor cap, fuel filter and carb. Not really sure where or how to start and any information is appreciated ! Need Help!!! Thanks, Gord

Where to begin... Well I have no spark in my 1992 Wrangler YJ 4.0 Automatic. Here's a list of what i've replaced: Crankshaft position sensor Camshaft position sensor (Distributor switch plate) O2 Sensor Ignition switch Ignition coil (replaced three times) Rotor button ASD relay I have around...

So I have a weird issue. The key that has been in the ignition will not lock doors or unlock. The spare key will work fine. We changed batteries in both fobs and disconnected the battery to reset. The only other thing is it usually says that the key is in ignition even when its been removed...

All, I have a 2014 Grand Cherokee Laredo with about 40,000 miles. The ignition switch(button) will start the car every time but will often (33% of the time?) not switch "Off" at first press. The car remains in "Acc" and the locking system will chirp if you don't notice and try to leave, lock up...

My Jeeps ignition switch had been annoying becaue I needed to really turn it all the way before the ignition would crank. Last weekend I lent it to my roomate and he managed to break it. . Basically the key in switch turns all the way to the right but only the dash lights come on and no...

My jeep has been yard art for the last 5 years. Trying to get it going I am redoing the wiring. Lots of lamp cord and duct tape used to "fix" problems in the past. It is a mess. Pulling out the wiring and putting in a Painless 22 circuit system. I have a wiring diagram and the diagrams in the...

I'm in the middle of replacing an after-market stereo in my 91 YJ. First I installed two new front dash speakers. I followed some of the instruction I found online and dropped the windshield and pulled the dash apart. Everything went smooth up until I connected the last wire to the back of...

Hey guys and gals: I have a 97 tj Sahara inline6 standard transmission. This is not a fuel pump issue. Sometimes when I go to start my Jeep NOTHING happens! No actually the lights and radio come on and it dings at me when I have the key turned to the on position. When I push the clutch pedal...

put in a new msd distributor with a built in ignition controller and re ran wiring to a toggle switch push button setup got power everywhere but from the coil to the distributor

I have a 1995 Jeep Wrangler YJ with MPFI. The problem is it will instantly die on the road, no missing or sputtering, then won't start. Cranks fine. Does start when it is good and ready. I thought it was happening when it had been running and was really warm. It would start after maybe 30...

This is probably elementary to most out there, but I had an epiphany and thought I would bounce it off the board to get some thoughts. I just put a new cam, lifters, timing chain, etc. in my 258 to refresh it a little. While setting the timing marks and such, I realized the true meaning and...

Hi folks. Long time no post. I have a 1990 Jeep Cherokee Limited 4.0 tilt-wheel 4x4. Every morning when I get ready to go to work, it starts fine. When I get to work, I will turn it off and try to start it again. ...Starts better than before cause it is warmed up. But, if I leave it off...

Is it easy to replace an ignition switch on a 91 Renegade?

I've got a 97 wrangler w/ 112000 miles. Runs great, idles smooth. The stupid thing will not start, even pumping the gas pedal. However, if I stop and reverse the ignition and start cranking again, it fires right up. What is the deal? A local Chrysler mechanic said it could be several different...