fit

  1. 2

    2023 exhaust

    I have a 2023 Wrangler 4 door Sport on order and want to put an Injen axle back exhaust and Injen cold air intake on it when I get it. I contacted Injen and because they haven’t actually installed any on a 2023 yet they won’t guarantee they fit. They advertise it will fit up to 2021. Does anyone...
  2. R

    front shocks

    anybody out there able to tell me which named and part number shocks will fit {replace} my original shocks IN the coil spring on front of my 1998 cherokee XJ...??? 4 wheel drive
  3. G

    Winch bump stop

    Warn winch bump stop will not fit 3/8” synthetic line (goes through hook and braided back into itself). Newbie question but hoping to see what consensus is for a bump stop that will fit that setup.
  4. D

    Frameless soft top won't fit

    Frameless soft top 2001 Wrangler won't fit, cannot get back window to zip to side windows, 2 to 3 inch gap. Side windows are zipped to top and are very tight. Got it to fit last spring after leaving it in the sun for hours. It was still a struggle and I thought the zippers would fail. After...
  5. D

    Frameless soft top won't fit

    Frameless soft top 2001 Wrangler won't fit, cannot get back window to zip to side windows, 2 to 3 inch gap. Side windows are zipped to top and are very tight. Got it to fit last spring after leaving it in the sun for hours. It was still a struggle and I thought the zippers would fail. After...
  6. C

    J-20 front axle

    I bought a 78 J-20 without a front axle. I found an axle that is supposed to fit. I don't have the ubolts though. It looks like one of the ubolts needs to be bigger than the rest of them because the spring pad is so close to the cast iron housing that the bolt has to go around that and it is...
  7. F

    Wheels and Tires from JK to JL

    Will 2014 JK wheels fit a 2020 JL. I know the lug nuts are larger on the JL
  8. M

    Door Hinge Bushing Fit

    For those of you that have replaced the bushings on your door hinges, what kind of fit have you observed on the replacement bushings of various types (plastic, metal, etc.) and from different suppliers? What did you purchase and who from? Were they too loose, too tight?
Back
Top