clutch

Ive always wanted a wrangler since i was a kid. well I recently bought a 2007 2 door jk six speed. When I bought it the clutch would make a squeeking sound, I just figured it was a rusty spring or something. But now it's developed another sound while not engaged almost like a ticking or a knock...

Ive always wanted a wrangler since i was a kid. well I recently bought a 2007 2 door jk six speed. When I bought it the clutch would make a squeeking sound, I just figured it was a rusty spring or something. But now it's developed another sound while not engaged almost like a ticking or a knock...

At a traffic light I had the jeep in neutral. The light changed to green , I pressed in the clutch pedal it would not go into 1 st gear. I went for second gear and it engaged. The clutch pedal seemed to be a little lower to the floor then usual, got home with no issues. Later that day I went to...

Does anyone know if I can lower the clutch pedal. My 2014 JK Pedal is really high and I'm constantly resting my Foot on the pedal and slightly pressing the clutch in while driving. I'm 6ft and its awkward to rest my foot on the side. Anyone else have the same issue?

I have a 2003 Jeep Grand Cherokee Laredo (only 175K miles) that had developed a new problem that I've never seen. I am hoping it's as simple as a vacuum leak and not a transmission that's about to go south. It has an automatic transmission, but last week it was acting (in town driving) like I...

The AC clutch recently blew out in my 2013 Jeep Compass (2.4l). The pulley itself still spins fine but the side of the thing is gone and needs to be replaced. I have replaced AC clutches before and would prefer to replace this one instead of replacing the entire compressor and all that goes...

Hello all. I have a '69 CJ5. It has the Dauntless V6, a T98 4 speed, what I believe are stock axles. I have been having an issue with the clutch. It is very abrupt on engagement. It will chirp the tires in second or reverse when you start out. Because the rear tires leave equal black stripes I...

I had the clutch replaced on our 87 Wrangler and now the clutch engages too close to the floor. The clutch is hydraulic and therefore I cannot figure out a way to adjust it. Any ideas? Also, I am new to this forum so I hope I am sending this question correctly!

I recently purchased a 2008 Jeep Wrangler and I am have issues with it during take off. It is a 6 speed, when I take off in first gear it seems like when I go to give it gas a release off the clutch it doesn’t want to go and the Jeep starts to shake until I fully get going. Has only one had this...

Hello again, the Jeep is a 99 TJ 4.0 I6 with 150k miles on it. I've been having what I believed were clutch issues but after talking to a fellow armchair mechanic he was concerned it might be transmission related. Here are the symptoms: The clutch pedal must be fully depressed to the floor to...

So, I finally bought a Jeep! A 1993 Cherokee XJ with a 3" lift. I never learned anything but the most basic car maintenance and saw this as an opportunity to learn, having a friend who is willing to help. I test drove the vehicle and everything seemed great. I made the purchase and got all...

I recently replaced my seized up AC Compressor, drier, and orifice in my 98 Sahara. Pulled a vacuum, verified no leaks, and put as much r134 in as possible without the compressor engaging. I used a 14 gauge wire to jump the low pressure and high pressure sides with no luck. When I jumped it...

I have a 83 CJ7 with a 4.2. The thing is when I traded for this jeep a few months ago it had a slight knock in the motor & could tell the guy had siliconed the crap out of the trans & t case mounting surface. Well long story short I built the engine and went through the trans & t case (T15 &...

So I was driving home the other day and I tried shifting but there was no resistance on the clutch pedal. I basically had to powershift all the way home. This has happened before but went away after a week or so.

Hi all. New jeep owner! just got an 88 cherokee laredo that needs some work. the master cylinder for the clutch is siezed, which I didnt know. so I added some fluid, tried pressing the clutch firmly and I pushed too hard. :roll: SNAP! the arm of the clutch broke! :cry: How hard is it to replace...

TJ, 2002, 4L, about 100000mi on it, manual trans Hi, A few weeks ago, I noticed that when I parked the Jeep on a small hill, turn if off, put it in 5th or reverse, let the clutch go, it would roll a little bit before coming to a full stop. This weekend, I parked it on a small hill and when I...

I'm a little stumped and my search for info on my problem didn't come up with anything that helped. The line from the fluid resevoir to the transmission for the slave cylinder rusted and broke where it transitioned from a hard plastic to metal. I cut the line and put on a compression coupling...

Hi I have a 93 Jeep Wrangler my clutch pedal suddenly stopped working. It has become extremely soft and can go all the way down without any resistance, it does come back up again tho.It was working fine when I parked it over night and the next day pressing the clutch pedal does not allow me to...