Search results

I swapped out a '95 2.5 AX-5 to a '94 4.0 AX-15.....You'd think easy peasy lemon squeezy right? WRONG!!!! Pain in the ass nothing interchanged and cutting out and repositioning the right motor mount.... I got too deep into it to turn back and just small block it. But, I scored on the 4.0 being...

Looks great...

I thought about "Modernizing" From my old YJ to a JK.....And after looking at four and ALL of them had replacement motors, I decided to stay "Antiquated",,,,,,,,

I've been thinking about "Modernizing" From my 4.0 YJ.....Scary thing is, Dang near all of the used JK's I've looked at have had replacement motors...So much so I've told the Missus that she's just going to have to put up with my Ol' '95 Turd bucket because she's never failed me and I can fix...

My Grrrrrrls........They LOVE Riding in the "J"........

Have heard good things about that....

Gutting the valve didn't do anything as far as locking up the rears......Just not getting near the amount of fluid to the rear as goes to the front. Guessing that drum wheel cylinders require a much smaller amount of fluid to function ie. Move the shoes into the drums than calipers need to push...

Installed a Teraflex rear disc conversion kit on the YJ. I HIGHLY recommend checking out others before going with this one. Had to grind the calipers down so 31's on 15 rims would turn without binding and low grade quality on fittings etc. I got everything to seal after getting a replacement...

Found out that the spring U hangers were ALL super loose......Tightened them down with a Milwaukee 1/2 drive till the bolts were angled......Drives straight as a pin now, Thanks!!!

Strangest thing I've ever seen.....When you get above 25mph, You throttle up it pulls to the left, But you don't feel a thing through the steering....Let it off and she pulls back right..... Same thing, It's a hard pull, But the steering wheel stays straight and you feel nothing through you're...

This is a new build, No lights, Idle around 975, And everything fuel wise, Pump....Injectors are new, And I run Lucas Injector cleaner everytime I fuel. Pulled the motor apart before installing and hand cleaned all intake ports and intake manifold including the throttle body. Buddy of mine who...

Thanks for the feedback fellas......Gonna snatch it out and have the tranny gone through, And rebuild the transfer case while it's at the tranny shop.

What I need sensor wise to "Tune" Up my 1994 4.0 HO? Want all that will balance the fuel air mixture.....She's smelling really rich at idle. All the plugs, Wires, Coil are new high performance and from a American manufacturer....Air filter a brand new Wix. Timing was set by an expert... And the...

No load, Only happens when letting out on the clutch first gear, ALL mounts are new, New track bar in the rear but not the front, Ran it a few miles yesterday and it didn't do it at all. All the gears were quiet except for fifth.....Which "Chatters" The whole time you're in it.

Just finished up swapping a '94 YJ 4.0 with an AX-15 into a '95 YJ and now on occasion when a let out the clutch I'm getting a LOUD popping coming out of the either the tranny or transfer case. I have the floor plate around the shifter removed so I'm hearing it real clear. All angles as far a...

Know a guy that took an old school mail jeep, The one with the sliding doors and dropped a .040 over 350 Chevy in with a two speed power glide. That jeep was ALOT of fun to drive!!