Search results

Well I jumped the relay(PCM Fuel pump from 87-30) and heard something kick on. I dont have my voltmeter at home so I cant check that now. I did find my ground (by the dist) and its connected still. This issue started when just changing out the bulbs and checking the fuses in/near the...

Mah Jeep wont start! The ignition engages the starter with solid crank. The O2 sensor cable/connections are safely secured and undamaged All fuses checked out OK. When I turn the key one step before ignition I dont hear anything 'kick on' (the radio and instrument cluster come to life though)...

Ha! Well let's just say that was the last time I let my ex wife borrow my jeep. It came back missing the pad, door handle broken off and the parking brake release lever snapped off. Ex's...

The foam on top of my console cover has been missing for a few years now. I didn't want to buy a new console just to replace the foam top so I found a bit of foam in the garage, cut it to size, and wrapped it in a scrap of my old soft top material. A few stitches, some silicon beads and a fresh...

I discovered through a series of rigorous tests that I could only disengage my clutch when my rear driveline was disconnected. Seeing as I had absolutely no idea what that could possibly mean I had to send it to the shop. Ok. So the shop said my pressure plate bolts were not tight enough...

Thanks! I'll give that a shot. Also, I didn't have instruction when installing the slave (concentric) an now I'm seeing articles detailing 'adjusting' the slave. I didnt know to do that. Could that also be effecting this?

Still having trouble with bleeding. A friend mentioned that there should have been an O-ring in the kit that replaces the one in the lines quick connect. Is this accurate? I didn't have one and the stores don't sell it... I guess air could be getting in that way...

Oh. Right. Clutch plate. Well I bought that new in a kit but i will certainly check it out.

Which part should I check? the flywheel? Thank you for the response!

I had the lines professionally bled but that wasnt the problem. The shop says that the clutch was either backwards or damaged during install. Just pulled it out again and it wasn't backwards. Doesn't look damaged either. Is there an easy way to test a concentric slave on my bench before I...

Thank you! I'll keep at it.

I thought the same thing about reverse pressure but if it able to be bled... How could both things be happening?

Do you know why I would be getting fluid out of the top of my MC?

So I just gravity bled and had a helper in he cab pushing the clutch methods. No luck but I did notice something: when the bleeder is closed and the clutch is pumped fluid squirts out the master cylinder lids pin hole.

6cyl / 4.0 Manual Installing New Clutch Kit Ok. Finally got everything off, resurfaced the flywheel, installed clutch kit, got all back together BUT now it won't shift with the engine running. The clutch pedal is firm and has consistent pressure. Is it possible that I haven't bled the line...