Search results

1048583 Please give me more detail as to where you see the leak in the line or master.If the leak is right where the line comes out of the master and you have a plastic master the line is held in with a tiny roll pin which needs to be removed with a punch and SMALL hammer,if the leak is inside...

1048584 The clutch master is located right beside the brake booster.Alot of the time have to pry up on the front grill support rod because the master is directly underneath it (engineers are soooooo smart). [addsig]

1048829 If you wire out the computer the need for most of all the vaccumn lines will be eliminated,because most of the vacumn lines are either sending information to the computer ie.ported and manifold vacumn positions. The only vacumn lines you will need are E.G.R vavle control (ported...

1048831 Sounds like clutch and release bearing are wiped out, re&re transmission replace clutch,release and pilot bearing. Drain and fill plugs are on the side and bottem of trans. The plugs are square in shape and ussually take a 5/8ths wrench to undo. Undo the lowest plug to drain...

1048835 This is normal for the line to pull in and out.Where the line goes into the actual slave cylender it has a o-ring to seal the steel line to the plastic slave cylender the steel line is in turn held in with a steel clip. So what you think is the line puling in and out is actually the...

1048836 there is a idler pulley below and to the side of the ac compressor identifing feature is a square hole that you can put a rachet into for tensioning after the bolts on the braket are loosened.hope I could help [addsig]

1048318 93 Yj has a Ax-15 transmission with an intrenal slave cylender controlling clutch dissengagement,easiest thing to check first is the clutch master fluid level.If fluid is low it's probable the slave is no good.As far as I can tell from the Chrysler service manual the AX-15 Trans. 80w90...