Search results

I am trying to fix a buddy's jeep that he drove off a 6' creek bank. The motor mount plate is bent very bad and I need to get the crank pulley off without damaging it. What puller will work?

I am running the ford 8.8 in the rear and the Dana 30 up front. I wa thinking about running a Spartan locker in the 30 and the ECTED in the rear because the cost of the cost of the ARB. I do not know anything about the OX. This is not a hard core Jeep. I only have 33's right now and might go to...

Having installed the 5.3 in the 1988 YJ I am now focusing on the axles. I want to know about the Auburn ECTED, ARB and any other selectable lockers. Just need input to help with my choice.

I am running the ax-15. It should hold up for a while then I plan to run the 4l60e.

I put a picture in my gallery.

1988 YJ with a 2002 5.3 Chevrolet V8 6" lift on 33's 4.56 gears

1988 YJ with a 2002 5.3 Chevrolet V8 6" lift on 33's 4.56 gears

After 8 months and 5700.00 and countless hours of fitting and fab work I finally got it running down the road. The guys at Novak Conversions are extremely helpful. Ken Brown and Eric are the guys to talk to. My knowledge is basic, I can change a motor and do basic mechanical stuff. This one was...

What kind of driveshaft shoul I use?

Another question. With the offset of the 8.8 is there going to be alot of drive line vibration on the highway?

How do I determine weather a trans is a ax5 or an ax15?

also, I am going with the x15 instead of the Peugeot. When I rebuild the tcase what input spline should I use?

I also just found out that I have to completely rebuild my D-30 front axle. Is it worth the rebuild? Remember cash is the problem. It needs ball joint and u-joints. So if I have to do that I might as well go through the whole thing. Input?

Here I am again with more questions. I am basically rebuilding this whole jeep. Should I rebuild the 231 with stronger parts or get a different t-case? I am wanting a good t-case for the least amount of cash. What are my options? Thanks Keith

It is the ABS sensor plug. All I have heard are positives about the swap. I picked up the rear end off Craigs list for 27.00 Yes, 27.00. I know that the calipers and rotors are 220.00 new. I thought that it wasn't a bad deal. I just know that my dana 35 is junk. I can lock up the 8.8 later. I...

How do I set the pinion angle?

I scored an explorer rear end for 30.00 bucks!!!! 373 gears and posi lock just need calipers and rotors. Sweet deal. Now I just need to know how to install it. It has the electronic in the top. What do you do to the drive shaft? Where do you buy new spring perches and the other brackets? Is...

Will the axels out of a rubicon work on my 88 YJ? What kind of modification will be necessary to make it work? Keith

I just completed the "Nutter" bypass. The jeep works a hundred times better now. I am not sure I did the timing as correctly as it should have been done though. I just did not know the correct RPMs at idle. I also have a driveline vibration at 3000 RPMs but that is another issue. Anyway, Thanks...

I did the timing the best I knew how to and the results are great. The jeep now idles at 800 rpms without stalling. There is still a miss but I think there is a vacuum leak. However, I do not understand the point of changing the vacuum lines from the distributor. Is the new location supposed to...