Search results

Hi I have a 1980 CJ7, 304, 727, Dana 300, Narrow AMC 20, Dana 30. My engine and transmission are finally done. I just found a 1989 Grand Wagoneer with rebuilt 360, 727, select trac, dana 44s front and rear for $500.00. My question is, will the transmission work or is there speed sensors and...

It is a passenger drop Dana 30 and an Amc 20 rear. Narrow track. Are leafs supposed to be excactly parallel?

Maybe I will try to loosen the u-bolts to the axles and they might center themselves. There is probably a centering pin there, no? I probably need 3/8" to 1/2" movement. I am assuming these are the stock axles.

They lean side to side. The bottom of the shackles lean out at all four corners. I measured the center to centers of the widths of all the mounts and they were all different by as much as 2" as well as the mounts on the axles. The spring hangers are bolted in their stock location. Do you have...

Success! I had to replace the tank and sending unit. The tank was pretty rusty and the sock filter on the sending unit intake would plug with sediment after driving for awhile.

:???: So I finally built a jeep and did the ussual frame off and prep work for a tough trail toy. It is a 1980 CJ7 mostly stock 304/ 727/ 300/dana 30/Amc 20 with 2.5 Rancho lift springs (already installed when bought), 2 " body and 35 BFG MT. My Question is, the spring hangers both front and...

I think I found the problem. My fuel bowl is not filling up all the way. I played with the float and cleaned the input. My replacement pump has good pressure when starting, but very little when running. Maybe a worn cam lobe? Either way I have an electric pump on the way. I like them better...

727 Auto, Dana 300, 2.5" Rancho springs and shocks, 1" shackle, 2" body, 35" BFG MT, 10,000lb Winch, Dual exhaust, Warn hubs, Boxed in and welded spring hangers, power leather RX7 seats, 360 AMC in the garage for next winters project, 4.88 gears, 1 pc axles, and twin stick on the

727 Auto, Dana 300, 2.5" Rancho springs and shocks, 1" shackle, 2" body, 35" BFG MT, 10,000lb Winch, Dual exhaust, Warn hubs, Boxed in and welded spring hangers, power leather RX7 seats, 360 AMC in the garage for next winters project, 4.88 gears, 1 pc axles, and twin stick on the

Hello. I have a 1980 CJ7 304 2100 motorcraft. The engine runs and idles great, but it has been stalling after I drive for 20 minutes or so. If you let it sit for a few minutes it will start again and idle fine, but as soon as you accelerate down the road a bit it stalls again and won't start...

Sweet!