Search results

Do not take apart the column!! You can see the little piece that is broken off inside the lever housing. Get a small drill bit (I used a 1/16) and drill a pilot hole, then use the next bigger bit to make it a good size for a wood screw. Slowly screw it in , just enough to let the screw get a...

Moral of the story is; check ALL the fuses, especially the one marked brake lights. thanks for all the info and help!!

I checked the fuse for the turn signal and it was burned. I replaced it and my signals work. BUT, still no brake lights. I am wondering if my switch is bad or dirty. I remember the guy I bought it from said he would just hose it out when he got done playing, which is probably what started my...

Well, I finally gave up. I got a resistor from O'Reilly's (an actual LED resistor kit - pictured) and my blinker worked. No brake lights though. Then when I was snapping the quick splice together I broke the flimsy wire from the resistor. Which was my breaking point. I then went to Walmart with...

Ok, I went to a couple of stores and "peeked" at instructions for LED lights (mine didn't have any, thanks ebay seller) and found out I was way off with the wiring. It is now correct, my running lights work, and my hazards work. Still no brakes or signals. Of course I did all of this before...

Hi everyone, I'm in a jam, I swapped out the stock tail lights on my 95 yj for round LED's. I am convinced I didn't wire it right though because I have no brake lights (only running lights), when left signal is on there is no change and when right signal is on the left light goes out. When I...