Search results

1044956 <TABLE BORDER=0 ALIGN=CENTER WIDTH=85%><TR><TD><font class="pn-sub">Quote:</font><HR></TD></TR><TR><TD><FONT class="pn-sub"><BLOCKQUOTE>Hey Bob, what's the story behind the dent, and don't tell me there isn't one lol </BLOCKQUOTE></FONT></TD></TR><TR><TD><HR></TD></TR></TABLE>...

1044958 $1,500? Jeep lists the new, better sail cloth top on their website for $1,100.. check http://www.jparts.com or http://www.jeepsareus.com[addsig]

1044960 <TABLE BORDER=0 ALIGN=CENTER WIDTH=85%><TR><TD><font class="pn-sub">Quote:</font><HR></TD></TR><TR><TD><FONT class="pn-sub"><BLOCKQUOTE>if you're SURE its the cat, just keep driving it dude... its just making a noise, its not hurting anything except maybe emissions... save your...

1044966 Check Bestop.. you can get their Sunjammer (I think that's what they call it) for less then that, was about $750 w/ hardware last I checked.[addsig]

1044967 http://www.jeepsareus.com[addsig]

1045025 did you swap in the 350 already? With that much power you'll wind up wanting to run 3.09s or 3.55s.. if you use lower gears (higher numerically) you'll get better accelaration.. if you use higher gears (lower numerically) you'll get a faster top speed For the most part higher...

1045054 I know a little about it.. I beleive it's on the eastern side of PA.. they are a bit over priced though.[addsig]

1045088 Got the web address: http://www.firstclass4x4.com/[addsig]

1045095 Keep your jimmy problems to yourself Start it up, check the voltage at the battery, if it reads below 13-14 it's the alternator, if it reads fine the battery isn't holding a charge.[addsig]

1045524 wet floors are common in TJs... what exactly do you mean by the door is wet? common sources are throug the HVAC ducts, door surround, door seal, and the upper soft door if you have them.[addsig]

1048841 <TABLE BORDER=0 ALIGN=CENTER WIDTH=85%><TR><TD><font class="pn-sub">Quote:</font><HR></TD></TR><TR><TD><FONT class="pn-sub"><BLOCKQUOTE>Get a manual throttle, less than $10 from a bike shop. Put mine on the shifter to keep rpm's up when winching. Makes a good poor-mans cruise control...

1048842 tought choice... if it had to be a daily driver, and FJ-40.. but I'd be dreaming of a Unimog.[addsig]

1048905 you got a fan club and you didn't even know it [addsig]

1048974 a shaft with a cv joint on one end and a standard joint on the other... not sure what size yoke the rusty's kit gave you but the size of the cv joint will depend on that.[addsig]

1048975 providing you have the proper tools to deal with them the torx bolts are stronger and allow you to apply pressure to a larger surface when turning them[addsig]

1048982 the SOA will give about 5" more if you use new springs or lift springs. not sure why they would say not to use the 3" Body lift with a suspension left unless it was for liability reasons, a 3" body lift isn't the safest choice out there.[addsig]

1048996 what type of Jeep do you have? a YJ? there's are some more simplier ways then welding... 1: You can chop your current links in 1/2 and drill them, but instead of welding a tube to one side you drill both sides of the tube and use two pins which is how the Rubicon Express...

1048997 POR 15 isn't cheap, and it doesn't last long on it's own at all if it ever sees sun.. if you do go with the POR 15 get the top coat as well and use them both.[addsig]

1049012 <TABLE BORDER=0 ALIGN=CENTER WIDTH=85%><TR><TD><font class="pn-sub">Quote:</font><HR></TD></TR><TR><TD><FONT class="pn-sub"><BLOCKQUOTE>>> 2: Keep your sway bar link intact, cut the pin off the sway bar and drill it out and use a hitch pin through the newly made hole as a quick...

1044000 My 95 just had two... I made two more in the back with a 1 1/2" hole drill and some tube caps.[addsig]