Search results

1062233 ANYBODY! :-( :-( :-( [addsig]

1062241 Yes, I did this swap on a AMC 360. How or why did the gear get destroyed?[addsig]

1062242 I have the same Nitros on my CJ 5, with 4" skyjacker lift. They were stiff for a couple of hundred miles but they get better. Had them three years now.[addsig]

1062243 Hey FISH, where you located? Are you selling it? What does it have in it? Thanks joeycj5@attbi.com :-O :-O :-O :-O [addsig]

1063416 What transmission and T/C do you have? :-? [addsig]

1063988 How about the driver side fender? What condition is it in?[addsig]

1076080 Looks pretty good, but, I have seen guys use the round LED tailights. Looks even better!!! ;-) [addsig]

1076081 Anyone! :roll: [addsig]

1076441 Yea, I have Lockrights in my CJ-5 with AMC 360, and front and rear Dana 44's. They are a bit noisy and quirky, however they never failed me out on the trails!!!! :-D :-D :-D [addsig]

1065847 It may, but it will burn up your alternater too. :-O [addsig]

1066423 Do you have a Driver side front fender? :-O [addsig]

1067256 $200 for both sets? You might as well buy them new. Hey SNITTY, you set up a rear end for the first time in UNDER an hour?????? :-O :-O :-O :-O :-O :-O :-O [addsig]

1067257 Where you at? I have one with a T/C![addsig]

1067328 Hey Snitty, I was just jaggin' ya. Reason I asked was, I talked to a garage that "specializes" in transmissions and rear ends. I asked them what it would cost to set up, My, already empty Dana 44 rear, I had all new gears, bearings, set-up & shim kit. He quoted me $350, and it...

1068283 Hello, I am not sure if they are spaced the same on a YJ. But on a CJ, you can unbolt the rear spring hanger and use these bolt holes to mount a Aftermarket tow hook. Yoiu can find these at Autozone or Advanced auto parts. The holes in the tow hook are exactly spaced to line up with...

1068889 Did you bench bleed the M/C, before you installed it???[addsig]

1068890 Are tires still avail??? ;-) [addsig]

1071785 Did you pack the axle bearings REAL good when you replaced the first axle?? First sign of bad or worn bearings is a axle leak! :-O [addsig]

1071989 On some u-joints, the fittings are installed on a slight angle. This makes it easier to grease them without having to unbolt the shaft. :-O [addsig]

1072528 Your from Colorado, and you say "Go STEELERS!" Cool :-D [addsig]