Search results

1054806 Did they end up sitting a lot higher than the stock seats.[addsig]

1054826 Hah? :-? [addsig]

1054929 What do they look like?[addsig]

1055012 AMC 360, T-18, 4.10's, and 33" BFG 2700 at 65mph :-P [addsig]

1055466 Like Dingus said, just get your diameter, and get a piece cut at a hardware or glass shop.[addsig]

1055793 Take the wheels and drums off, one-by-one. Then s-l-o-w-l-y push in the brake pedal. Do the calipers and shoes move when doing this?[addsig]

1055794 OK< you have the traditional 2-piece axle shafts. You need to take the wheel and drum off. Then take off the brake backing plate, I believe there are 5 or 6 bolts behind the hub that you need to take off for the backing plate to come off. Then you need to put that hub you removed...

1055795 It depends on how much you go off-roading. For casual off road a lockright would work. For extreme use a detroit or ARB is great, gives you the option of locking and unlocking, cost a lot more.[addsig]

1055796 Yup, it is either a T-177 or T-176, basically the same transmission. T-177 has a bit lower gears. But, sound as if the synchronizer is shot in your transmission. :-( [addsig]

1055979 How is the clutch? Is it adjusted? or have proper fluid?[addsig]

1056377 Check out E-bay, all kind of Jeep seats (and Mustang!) :-O [addsig]

1056379 Once you have the nut off, use a 2 or 3 jaw puller to get the hub off. $25.00 at Autozone.[addsig]

1056380 I thought the 3.73 carrier will also Hold the 4.10's?? :-? [addsig]

1056937 Do you Still have the Axles? They are widtracks, right? What ratio? Thanks -joe[addsig]

1057153 LT325/60R15/C AT? 325: Section Width in millimeters (Conversion: 325 mm ÷25.4 = 12.80") 60 :Aspect Ratio (Conversion: 12.80" X .60 = 7.68" (sidewall height 60% of width) R: Radial Construction 15: Rim diameter in inches So this tires is 30.36" in diameter ( 7.68"...

1057157 Not quite!!! I used to sell tires. :roll: [addsig]

1050701 I have the exact same set-up in my Jeep, except, for an AMC 360. I almost positive you are running lean. Rejet a COUPLE of sizes more rich. Also, When you installed the intake are you sure all gaskets lined up and went in right? [addsig]

1050827 44 would be better. But you would have to move the perches, in, to line up with your springs. While your doing this you can mount the perches spring over or spring under. Or put outside-of- frame spring hangers on the CJ. As far as the burned up bearings on your original axle, you...

1050828 Great, Is it narrow or wide? Is it complete? What is gear ratio, (if known)? Thanks [addsig]

1050933 Snitty, are you sure it is from a Cheer? That will not bolt in to a CJ... Check the distance from wheel mount surface to wheel mount surface, please. also, could you meas. the distance between the spr. perches. Thanks[addsig]