Search results

I need a Jeep T-176 or 177 4 speed either from Cj or Cherokee/ wagoneer. Need ASAP for a QUICK swap :cry:

Not many manual transmissions have a breather on them. :wink:

Hello "jhiggins" tell me about the driver side CJ fender you have!!! What kind of condition? How much??? Thanks

I have had good luck using the Skyjacker Nitro shocks. I bought them from WWW.4WD.com

I have had lockrights in my CJ with AMC 360 and 33" tires for three years.. With moderate to hardcore 4wheelin. Never a problem, have broke a couple of axles and driveshaft though!!! :roll: :roll: :roll: :roll:

Hey "rickcj5" do you still have that driver side front fender??? I tried to PM you, no response!!!!

Has anyon else lost the number of post they had listed under there name? I was near 100, now I am back to "0" :cry:

Is anyone going to the Canfield, OH 4wd jam this weekend? Also, does anyone know if the Rockcrawling course is going to be there this year? I received a couple of brochures, but no mention of the Rock course. :?

1045198 It is the master cylinder leaking, it cost $25, remove the two brake lines on the outside of M/C. Then remove the two bolts holding M/C. Disconnect the brake pedal linkage and remove old M/C. Replace with new, and bleed brakes again.[addsig]

1045199 I replaced the stock axle shafts with mosers, and replaced rear end gears with 4.10's. Runs great with 33's[addsig]

1054115 What kind of vehicle? :-? [addsig]

1054182 The main reason why I upgraded mine was to make the ignition/distributor more waterproof. The stock set-upin a AMC 360, with prestolite ignition, sucks as far as waterproofing. But if you use the MSD ignition box and disrtibutor, they work great They plug right in to each other...

1054183 By the way cjshag, what is your particular problem? :-? [addsig]

1054199 You may have a bad or clogged Cat. converter.[addsig]

1054212 Hey, cjshag, Your runnin a AMC v-8, right. You say your timing is at '15' Deg.? My AMC 360 is at '8' Degrees. It doesnt like anything else. I went back and read all the post on your "RED HOT Headers" WOW, you should have wrote a book. Is it fixed yet? :-O [addsig]

1054316 I run an edelbrock AMC R.V. cam and intake. When you say timing problem, is it Cam timing or ignition?[addsig]

1054572 SORRY, THE ORIGINAL LINK DID NOT WORK!!!! :-( [addsig]

1054775 Yea, I have a Master cyl/booster and prop valve off of a mid 80's wrangler. I just didnt know if it needs to be swapped or not.[addsig]

1054784 You mean there is a check ball in the M/C? Where is it? I will try anything before switching over Prop valve.[addsig]

1054791 I did find this page about the swap. http://www.jeepaholics.com/tech/mustangseats/mustangseats.htm :-O [addsig]