Recent content by Wranglermudder2011

Got 02 sensor seemed to fix the check engine light but i still got a mild studder every now an again i put fuel system cleaner in it to see if that will help and hints? And i also have like bad bad wheel hop if im cruizin and hit a bumb it starts bouncing and jumpin really bad i have to...

About 600 idles fine now that i changed the sensor it just ha hickups threw out the driveing range randomly

Ya i fixed the exhaust it leaks a little back bye the muffler but its not bad

Will have to look into that thank u i was always told the bosh platniums and such are bad to run in the i 6 its better to use the cheaper plugs but ill look into that thanks

And idk the part number off hand on my plugs but i think there ac delcos or a cheaper brand like that and they only have bout 650 miles on them

I havent had the chance to check the codes again amd it came on after about 8 miles of driveing and but i did reset it bye disconecting the battery but i didnt turn the key on and the exhaust is fixed and completly sealed off from the head to the end um i checked and cleaned a few grounds theres...

I changed the sensor there was disk under neith it or around it at all it seemed to take the miss away but it still does some funny studder threw driveing rang any ideas about that problem?

I cant get the disk today gotta get it tomorrow its 3 bucks the sensor was 43 though i got it gonna get back to u guys with it tomorrow after my shift and give yunz an update thank u

Thanks for the tip

See thats what threw me for a loup its not actually called a cam sensor thank u i guess for 25 bucks ill just change that first and see what it does

For the cam on the 97 4.0 so i gotta change the distributor cause the only thing they bring up for the cam sensor at auto zone i a fiber disk?

Oh and i re scanned the codes today the 02 sensor code is still there but its throwin a camshaft possition sensor code but i dont have a camshaft possition sensor on that engine

Is that the fist 02 and i do have a leak right after my manifold i have an aftermarket banks tourgue tube power catback exhaust on it and the plates for the bolts to attach it to the manifold it disnt come with a new one so the bolts pulled threw the rust i was gonna work on gettin that fixed...

I pulled my intake air sensor to try and clean it and it was covered in a layer of black goo but i still dont understand y its throwing a cam sensor code when i dont have a came sensor

So i went to auto zobe to scan my codes again to see if snything chsnged now i have a cam position sensor but i dont have that on my engine and still throwin the code for it running to lean in bank one??