Recent content by Engir

The S10 and S10 Blazer are not even close. This is taken from dead Jeeps and they want $319 for it others on eBay around $250 and it is the same regulator for 2 and 4 door Jeep XJs

I have an 87 XJ with manual windows. My passenger front window is skipping teeth is there a rebuild kit, does someone sell them, or is there an interchange with another vehicle?

What I am thinking is get the front and change it to 3:07. The Front axle of the Rubicon is 30 spline as is my Dana 44 rear axle and both are open diffs which I do not like I would like to make the rear posi and the front limited slip

So, I have to change the gears or get both axles from the Rubicon

I have it working I had to adjust the relay a few times but got it working. I still think doing away with those parts and using a piece of conductive metal is a better way. Anyway 84-01 the turn signal cancel cam is part number 4487816 and 4487816K the "K" designation is for tilt wheel. Omix...

I took some images of what I have and would like to ask if this looks right?

I was having trouble explaining this so I made a video and uploaded it to YT.

The pump comes on when you turn the key to the ON position and I can hear it run until it builds up pressure then stops which could have been a sign that the pump was losing pressure but on other forum post people talk about it being normal, in fact some of the forum posts recommend that you...

I went on Amazon a short time ago and purchased another fuel pump assembly from it is a CARTER it should be here in two weeks. Is there any reason I cannot hook the pump to body harness to make sure the pump engages and move the float up and down to make sure the gauge is working properly before...

So, you do not think it is the relay or fuse? I have been trying to find out what wire does what on the body harness but have not found that information. I had a thought (You should be scared 😱) I got this off the old pump and have removed one of the wires I am old, eyes kind of iffy on stuff...

I want to post an update for this issue because I am having an issue. In this first image you can see my fuel gauge without the pump/sending unit plugged in and the second is with it plugged in Doing some searching I found that the harness for the new pump/sending unit was assembled wrong...

At this point I think I am going to stick to stock from Quadatec because one Stock is more reliable and two cost but I am still considering so right now I am starting to purchase what is needed to rebuild the steering or front end I have a lot of play and vibration this will get me moving toward...

Yesterday I had a 45 minute conversation with a tech at Quadatec from this, I was told that to do a 3" lift I have to get in this case the rough country sway bar drop kit and I have to change the upper control arms to adjustable, and the track bar also need to be adjustable. I am looking to...

I have a 1987 Jeep XJ rear axle is a Dana 44 with 3.07 gears. I have a manual and the 4.0 the front axle is a Dana 30 if I wanted to swap a Dana 44 in the front my research says, "You can use a TJ Rubicon Dana 44 front axle from 2003-2006 (the years the TJ Rubicon was produced) on your 1987 Jeep...

Thank you