You will need to remove the steering wheel, steering lock plate and retainer, horn button connector, turn signal switch and ignition tumbler. Remove the spring cup on the tilt column with a large phillips screw driver and pull the spring out. Remove the the tilt pins on both sides and pull the upper column off. you will need a small torx socket( i dont remember what size). There will be 4 of the torx bolts holding the lower end of that column to the base. Remove them one at a time and apply a dab of red loctite then re-install. do this on all 4 and re-assemble the column. You will not have to worry about it for a long time.