mercab18
New member
I recently went offroading with a buddy and the check engine light went on. After getting code 24 (Throttle position sensor input above the maximum (or below the minimum) acceptable voltage; or TPS signal does not correlate to MAP sensor) and changing the TPS, the check engine light turned off.
It drives fine, but when I stop with it in gear (drive, reverse, 2, or 1), the RPMs are extremely low, probably about 500. You can see it dropping until it hits probably 200 RPMs and then it jumps back up to 500. If I put it back into neutral or park, it goes back to its usual 1000 RPMs, but it chugs while I'm in gear. It even stalled on me once while I was stopped at a light.
Any help is greatly appreciated. Thank you.
It drives fine, but when I stop with it in gear (drive, reverse, 2, or 1), the RPMs are extremely low, probably about 500. You can see it dropping until it hits probably 200 RPMs and then it jumps back up to 500. If I put it back into neutral or park, it goes back to its usual 1000 RPMs, but it chugs while I'm in gear. It even stalled on me once while I was stopped at a light.
Any help is greatly appreciated. Thank you.