driveshaft length????

[mag955i]

1075695

I just put a 4.5" lift on my 94' YJ and want to switch the rear driveline by installing a Rubicon Express slip yoke eliminator and CV driveshaft. My question is how to figure the length I'll need. Do I measure from the rear of the T-case to the center if the rear U-joint or do I measure from somewhere else??? This is to determine what length new driveshaft I'll need. Any help would be greatly appreciated,
(I have a stock NP 231 T-case and stock driveline now)
thanks a lot,


rich[addsig]

 

[Snitty]

1075702

you should be able to ask RE and they should be able to tell you[addsig]

 

[mag955i]

1075705

Why does the obvious always seem to escaspe me:-?

thanks, I'll give 'em a call

rich[addsig]

 

[Bounty__Hunter]

1075757

Look in any 4wd mag for a Tom Wood's Driveshafts add and it will show a diagram on how to measure. May also be on the website. Best bet is to call RE.[addsig]

 

[jprtroy]

1075758

They'll probably tell you "measure from center of yoke to center of yoke with the vehicle sitting on level ground. Afterall, between those two points is where the driveline will be right? It's allways good to ask whoever will be making the driveline also.
[addsig]